Create: Camber

Create: Camber

Per-wheel camber angle tuning for Create: Aeronautics wheel mounts — tuned with the Create: Tracks+ Suspension Key.

Give your vehicles real stance. This addon adds a CAMBER tuning mode to the Create: Tracks+ Suspension Key, letting you dial in the camber angle of every individual offroad Wheel Mount from Create: Aeronautics — and the tilt is rendered live on the wheel.

Features

• Per-wheel camber, −30° .. +30° — each wheel mount stores its own angle; adjust in 0.5° steps (server-configurable)
• Suspension Key integration — a CAMBER mode is injected into the key's existing tuning cycle (existing modes keep their behavior): use = +1 step, sneak-use = −1 step, with action-bar feedback showing the current angle
• Physics with a purpose — lateral thrust proportional to −sin(camber) × friction × contact is applied at each mount's contact point, so negative camber on both sides pulls the vehicle inward through corners
• Live renderer — tilt is applied before wheel spin (steer → camber → spin); when Tracks+ is installed the tilt blends into its adjustable wheel-mount renderer
• Works without Tracks+ — a built-in fallback renderer draws the wheel mount with the same tilt
• Server config — thrust strength, max angle, adjustment step
• English + 日本語 localization

Requirements

How to use

1. Craft / obtain the Suspension Key (from Tracks+)
2. Right-click in the air to cycle tuning modes until the action bar shows CAMBER
3. Right-click a wheel mount: use = lean out (+), sneak-use = lean in (−)
4. Watch the wheel tilt in real time