Schematic Placer

An addon for WorldEdit that streamlines placing schematic files in Minecraft.

Commands

schemplace <filename> [<pos>] [<ignoreAir>]

loads and places a schematic. Loading is done asynchronously and placement happens over multiple ticks if necessary (see batchSize).

schemremove <filename> [<pos>] [<ignoreAir>]

Sets blocks to air that are contained in the schematic. Uses the same loading and placement logic as 'schemplace'.

schemanimate <filename> [<pos>] [<ticksPerFrame>] [<start>] [<end>] [<step>] [<loop>] [<removeWhenDone>] [<clearPrevFrame>] [<ignoreAir>]

Sequentially places schematics using the same logic as 'schemplace'.

schemstopanimate <filename> [<pos>] [<ticksPerFrame>] [<start>] [<end>] [<step>] [<loop>] [<removeWhenDone>] [<clearPrevFrame>] [<ignoreAir>]

Stops any currently running animation that matches the given parameters.

schemwait <ticksToWait> [<waitId>]

Waits for the specified number of ticks

schemstopwait <ticksToWait> [<waitId>]

Stops any currently running wait task that matches the given parameters. Note: use the waitId to avoid overlap.

schemstream <port> [<pos>] [<skipLaggingFrames>] [<removeWhenDone>] [<clearPrevFrame>], [<ignoreAir>]

Opens a port and begins streaming schematics via TCP. A new client connection must be made for each sent schematic.

schemstopstream <port> [<pos>] [<skipLaggingFrames>] [<removeWhenDone>] [<clearPrevFrame>], [<ignoreAir>]

Stops any existing stream that matches the given parameters.

schemsequence <line>

Runs a sequence of comma-separated commands. Supported commands are 'schemplace', 'schemremove', 'schemanimate', 'schemstopanimate', 'schemwait', 'schemstopwait'.

schemstopsequence <line>

Stops any currently running sequence that matches the given parameters.

schemitem <line>

Attaches a command (or list of comma-separated commands) to an item by adding the command to the item's Lore. The command(s) are activated using right click. If there is just a single command attached, shift right clicking will invert the command e.g. (place -> remove) or (start -> stop). If there is a sequence, shift right clicking will stop the sequence. Supported commands are the same as those supported by 'schemsequence'.

schemtask list|stop|clear

Provides access to the schematic task queue. 'list' prints out all queued tasks. 'stop' stops all queued tasks. 'clear' forcibly removes all queued tasks.

schemreloadcache

Reloads the schematic cache assuming cacheSchematics is enabled.

• Note: running a command that is already running will instead pause or un-pause the task.

Configuration

The config file will be located in the .minecraft folder at config/schemplacer.json.

batchSize

The maximum number of blocks that can be placed per game tick.

cacheSchematics

Whether to cache all schematics into memory to increase placement speed.

schematicDir

Path to the location where scematics are loaded from. Accepts local paths to .minecraft or absolute paths.

commandOutput

Whether to output command feedback to the player.